Status
Not open for further replies.
my J (a) alg has a R L at the end, how can I do this in 1 motion? i sometimes do it sometimes don't when I do i get around 2-3 secs when I dont and fail id get 6 seconds+ lol, how can I do the R and L in 1 motion? or are there any better alternative J (a) perms
You could try to finish with (R r) or (L l).
 
That's rather silly then I can't adjust the tensions when they go to crap after the cube gets cleaned

Put one or two tiny drops with a toothpick. It works as long as you put very tiny drops (almost microscopic).
Since it's a Dayan cube, is there extra plastic on the center caps? My guhong center caps were popping out like crazy until I scraped off the extra plastic.
 
I'm going to get Cubesmith stickers for my Guhong. Should I get the small size or the regular size(in other words, which size will fit my Guhong best)?
 
How do you make the pyraminx turn better? The clicky feeling gets kind of annoying.

I'm going to get Cubesmith stickers for my Guhong. Should I get the small size or the regular size(in other words, which size will fit my Guhong best)?

If you're pretty accurate with your stickering, it's down to personal preference. I think regular size looks better because I think my F2 size stickers show too much plastic on my Guhong.
 
Last edited:
Status
Not open for further replies.
Back
Top