Status
Not open for further replies.
My yellow cap keeps popping out while I'm speedsolving. What should I do to keep it in place?

What I do is I spray a little sylicone where the edges of the cap make contact with the center piece. Let it dry, it should be stuck in place but not that hard. So with enough force you can easily pop it out again to set tensions.
 
What I do is I spray a little sylicone where the edges of the cap make contact with the center piece. Let it dry, it should be stuck in place but not that hard. So with enough force you can easily pop it out again to set tensions.

Thanks, but I don't have any sylicone. Anything else?
 
Status
Not open for further replies.
Back
Top