Reeny Cubing
Member
- Joined
- Sep 25, 2019
- Messages
- 6
Try tightening the screw with a screwdriver if it’s accessible
Don't do this, use the tool it came withTry tightening the screw with a screwdriver if it’s accessible
The GAN X numerical doesn't have a screw you can tighten. You get nuts that can go from 6 to 10 mm. 6 is tighter, 10 is looser. If you have it set to 6 mm and you have the strongest springs, sell it and get a cube that suits your wishes better.Cube
I set the screw to be level with the top of the compression area. Then set the compression between 3-6 depending on your preferences. I live the tracks with a little Traxxas then 2-6 drops on silk into the cube. Fast and stable. Works greatI'm trying to get my GTS3M to perform well. I have Traxxas 50k, DNM-37, Silk, and Compound X (which I'm not too fond of.) Give me your setup recommendations. I'm also trying to get the right tension and everything. Thanks!
I'm trying to get my GTS3M to perform well. I have Traxxas 50k, DNM-37, Silk, and Compound X (which I'm not too fond of.) Give me your setup recommendations. I'm also trying to get the right tension and everything. Thanks!
I have two Gan XS's. a stickered one and a stickerless one. The stickered one feels amazing and it has incredible corner cutting, as it should. My stickerless one, however, is a bit slower. It feels like it has more friction, and more importantly, the corner cutting is really bad. Both cubes are on the exact same settings: clear thing on 4th click, light blue thing on #3. The only difference is the stickered one has just factory lube and the stickerless one has been lubed with Martian, but this has been happening since I took it out of the box. I'd really like to know how to fix this.
Here's a video showing the difference:
i said in my post that both cubes are on the exact same settingsTensions...
i have, he did say the corner cutting wasn’t too impressive when testing but in solves its good. this cube locks up on me like crazy, the stickered version doesn’t.Watch J perms review of the Xs
my friend has the tengyun and i’ve tried it and the magnet strength is way too weak for me. i’m still gonna get it though because it’s so amazingly quiet. thanks for the recommendation.Sorry to hear that dude. That sucks bad. Look into the Tengyun after you get your money back.
Sent from my iPhone using Tapatalk
Tensions are different - lets say you have your cube on yellow nuts. This is compressing the screw. But how much the screw was screwed down to begin with still matters. Check it out.i said in my post that both cubes are on the exact same settings
this is a gan xs, there is no screw. screw depth is controlled by a blue plastic thing and there are no ges nuts, just a clear spring capsule that can be adjusted, not replaced. both cubes are on the exact same settings for both of these things.Tensions are different - lets say you have your cube on yellow nuts. This is compressing the screw. But how much the screw was screwed down to begin with still matters. Check it out.