screw

Hi, this is Jack Triton Recently, I bought mf8 Square-1 and got around 20 seconds with this method (which I would never been able to reach with Vandenbergh) I call this method JQ method last week, got no reactions so I dig up and find several problems Now I can say this method is fully...

Hi, I'm Jack Triton. Recently, I started solving various puzzles such as FTO, Master Skewb and Square-1 When I look up the method called Lin, I notice that it can be much easier if you separate U edges and DB DF edges to 2 part I'll explain how to do it on this article JQ Method CSP, Cube...

EI wanted to know if there is any website or PDF about the screw method for advanced square1,Because I thought of intermediate and advanced variants for the screw method.

A screw is stripped. How do I fix it.

I just got a LanLan but because i took it apart too much and unscrewed it a lot, the screw wont stay in the little hole no matter how many times i twist the screwdriver. will the cube still work if i glue it in?

Hey guys, im still relatively new to cubing ( 2 months ) and i have purchased a white Guhong from icubemart. I love it, however there seems to be a slight problem. No matter how loose, or how tight i adjust the tension screws, the tension doesn't change. The white and yellow sides are so lose...

Ok, because it is old 5x5 mech and pre-lube with a gooey Mefferts lube (but a very even coating) you must clean it. remove caps adjust tension Lube and break in. here's the problem with screw/core the screw unwinds itself. go to home depot or other hardware store. buy the most EXPENSIVE...