Labano
Member
My rs3m pops even after tightening it so what should I do?
It could be your turning style, how would you describe it? If it’s not very accurate this could be the reasonMy rs3m pops even after tightening it so what should I do?
Well then that’s what you need to work on, i find for me a tighter cube locks up more but you do what you want. It’s not the cube though, so i wouldn’t blame a cube until i’m sure it’s nothing about me or my turning style or whateverDuring my F2L I try to turn with accuracy there may not be to many lockups but in my last layer I lockup a lot.
When you get used to a cube, you start to subconsciously abuse it. Most likely your turning style has gotten worse since you got it.But at first it was completely ok then it got worse
Ok thanks I will tryWhen you get used to a cube, you start to subconsciously abuse it. Most likely your turning style has gotten worse since you got it.
I would recommend cleaning it out, re-setting it up, and tensioning to try to fix the problem.
The black-Grey stuff you mentioned is just residue that has been created because of the spring/screw grinding the plastic. It's natural and I think can be prevented by luring the core. Lube also might affect corner cutting.I have a problem with my rs3m 2020 too. It doesn't corner cut anymore. Well, it does, but it's very difficult even at about 20-25 degrees (reverse corner cut is worse). I already cleaned every single piece of the cube, and tried the other screw settings but it doesn't change. Has anybody an idea of what happened and how to fix it?
And I don't know if it's related but inside the center pieces there was something black-grey that dirtied the centers (only inside).
Just to add some other information: lube hasn't arrived yet, so I've never lubed my cube since I got it (2 months ago)
ok i will try itProbably just needs break in. Do 50-100 solves.
Probably something slow like nebula, and personally I like stock settingsI have just received a Gan 251 m pro and use speedcubeshop lube. I was wondering what you guys think is the best setting and lubes for this cube.
I’d recommend loosening to help alleviate the lockup’s from tightness and use a thick lube to slow the cube down. I personally go to angstrom dignitas and gravitas for adding control and reducing a. It if speed to my cubes.I just received my gan 11 m pro today, and the cube is just impossible to control. A normal force flick turn frequently turns the cube 1.5 or even 2 full turns, and I've got the cube on the tightest settings. I get so many lock ups during solves because of it. Is there any way to salvage it or is it just not the cube for me?
Can someone give me some tips on this?And I also have a gan 12 maglev and was wondering what were the best tensions for it
Personally I haven't been able to find any good tensions for myself so I have no idea. Imo it isn't a very good cube, so you will just have to figure out what you like bestAnd I also have a gan 12 maglev and was wondering what were the best tensions for it