abunickabhi
Member
Screws getting bent by tightening the cube?So I was doing as @abunickabhi was saying and found bent screws in my cube
Screws are of good quality nowadays yo.
Screws getting bent by tightening the cube?So I was doing as @abunickabhi was saying and found bent screws in my cube
Edit: I got this cube in November, do you think tc will still send me a new screw?Screws getting bent by tightening the cube?
Screws are of good quality nowadays yo.
You can order a part from all over the world, and if I told you to stop using your main 3x3, I think you could see the problem here. Also, it won’t harm the rest of the pieces, just make the current one worse.Which is this cube? Don't use it, it will harm the other pieces and yea i think you got it. If you live in the USA you can order a spare part.
Its better to not struggle with old hardware and just buy the new cubes like YJ MGC 3x3 and Moyu RS3M cube.So I've owned an AoLong V2 for about 7 months now, and I've never gotten it to be able to corner cut more than about 30 degrees. If I apply enough force, I can get it to do it, but I probably can't apply that same force while I'm turning. I've seen a lot of reviews saying that it can corner cut more than 45 degrees. I remember reading somewhere about there being two batches of AoLongs, and I really can't tell the difference between them. I bought them from a Swedish website because I live in Norway. I'm not sure if they have both or only the bad batch, but I did buy them in 2020. For clarification, as far as I can tell when I pull down, the corner in the back catches on the center.