kliang9299
Regular
- Joined
- Jan 25, 2014
- Messages
- 78
Maru CX3 soft springs. Thecubicle sells them for $1.00
Best spring swap mods
- Thread starter SenileGenXer
- Start date
Maru CX3 soft springs. Thecubicle sells them for $1.00
AlexGJohnson
Regular
maru soft springs
Mnts
Regular
But those seems quite rare to get. Any other similar options?
kliang9299
Regular
- Joined
- Jan 25, 2014
- Messages
- 78
Thecubicle sells them. As far as I know, those are the softest 3x3 springs and they make the Yuxin really nice.
dboeren
Regular
TheCubicle did sell them at one point, but they are marked "out of stock" currently with no indication whether they will be restocked or not.
Is there an alternate suggestion that can be used in the meantime?
Is there an alternate suggestion that can be used in the meantime?
2180161
Veteran
You can't spring swap on a Gans 357 right?
If you can, Meiying springs?
If you can, Meiying springs?
SpeedCubeReview
Veteran
There is a spring set you can get for the 357 with 8mm and 11mm. The regular is 9mm. It was one of the first videos I made. I really liked the 11mm, it made the cube feel bit more solid without loosing too much speed.
Ethan Emory
Member
Is there any way to make 42mm mini zhanchis better? I was making force cubes, and the cubes kept popping as I was trying to put the third piece in. Any tips?
2180161
Veteran
Shengshou wind/aurora (whichever is newer) with Sulong springs
EzCuber
Regular
how does that one feel
2180161
Veteran
very unstable feeling, reduces corner-cutting (not by much) and increases speed a lot.
SpeedCubeReview
Veteran
Hello, I am wondering if the extra spring set for the gans 356 is worth it, or if the normal springs are fine, also, anyone know where to get maru cx3 soft springs, always outta stock on thecubicleThanks though!
The normal springs are fine, but the extra set gives you a total of 4 options. Definitely worth the extra buck or two after spending over $20 on the 356. I made a video last week testing them on YouTube.
Sent from my iPhone using Tapatalk
EzCuber
Regular
57mm one I'm pretty sure.
JamesDanko
Regular
Has anyone tried weisu soft springs in a Mini Along, Mini Weilong, or Dayan 2x2? If so, results?
MoYuCuber
Regular
With the mini aolong the screws stick out too much so no centercaps can fit. Maybe if you cut the springs, it may fit
theROUXbiksCube
Veteran
Dayan 2x2- its really fast and reduces most of the pops if you tighten it a bunch, but its still really fast because of the springs, corner cutting was around the same as well
2180161
Veteran
Hualong springs in MeiYing:
Speed increase, corner-cutting increase.
Feel: Still the same turning feel, but seems unstable
Pops:The pieces are slightly easier to remove, but it does not seem like it will be a problem.
Corner-cutting: 45 forward, line-to-line reverse
Speed increase, corner-cutting increase.
Feel: Still the same turning feel, but seems unstable
Pops:The pieces are slightly easier to remove, but it does not seem like it will be a problem.
Corner-cutting: 45 forward, line-to-line reverse
Last edited:
