Tensioning Gans 356 Air UM

Kevin4

Member
Joined
Mar 30, 2017
Messages
5
A couple questions about tensioning the UM.

1. To make sure all sides are the same tension, do you just eyeball it? There's a little silver thing that sticks out of the GES, do I just make sure the same amount is sticking out on all sides?
2. I have taken the cube apart once to clean and re-lube it and I changed the tension when it was put back together. After having done that, I am noticing the corners seem to be a little loose, something I didn't notice at all when I first got the cube. Is this normal, or did I do something wrong?

Thanks everybody.
 
Eyeballing is pretty reliable for the GES system on the UM. I use a combination of eyeballing and using my pinky finger and feeling if the nut is flush with the screw. I screw in until I feel the screw poking out with my pinky, then loosen a side in small increments, while feeling with my pinky until I just barely feel the screw poking out from the nut. After doing this on all sides, I eyeball and find any that look like they're sticking out further than others and adjust accordingly

For your second question, I'd say it probably has to do with your tensioning, it may be fine once you retension the puzzle, otherwise I'm not too sure on that one.
 
Back
Top