GAN 356 Tension

pdtek

Member
Joined
Apr 2, 2016
Messages
4
Location
Iowa
Hello all- I'm a newbie here so if my terminology is a bit off, please bear with me.

I just bought a new GAN 356 and out of the box it is very fast. Much faster than my favorite cube, the MoYu AoLong V2. I wanted to slow it down a little so I increased the tension a bit until it had about the same amount of friction as the AoLong.

The difference though, is at that tension, the GAN has a sticky or tacky feel. What I mean is that the surfaces of the cube tend to stick together a bit until the tension is broken and the layers then slide easily over each other. I hope I am describing this correctly. This effect detracts from the smoothness of the feel, and the AoLong does not do this to a noticeable degree.

What can I do to eliminate the stickiness? Do I lube it? At the same time I don't want to make it faster. Or should I just accept the cube on it's own terms and learn to love the speed?

Thanks in advance!

Dave
 
You can add some xiaowan or D39 oil.
Or loose the screw and add some stick increasing oil of Gan.
 
Back
Top