GuRoux
Member
- Joined
- May 6, 2013
- Messages
- 1,712
- Location
- San Diego, California
- WCA
- 2014TANG03
- YouTube
- Visit Channel
Hmm. My Thunderclap is rather weird. My tensions cannot be equal (meaning I cannot tighten each side by 5 turns) because if I do put equal tensions for all sides, some will either be loose or super tight, so all the sides doesn't have the equal number of turns but corner cutting is just about the same. Anyone has this problem?
this happened to me with my weilong. it turned out some of the sides had washers and some did not. check if all your sides have washers.