TK 421
Member
Ok, because it is old 5x5 mech and pre-lube with a gooey Mefferts lube (but a very even coating) you must clean it.
remove caps adjust tension
Lube and break in.
here's the problem with screw/core
the screw unwinds itself.
go to home depot or other hardware store. buy the most EXPENSIVE threadlocker.
USE BLUE threadlocker.
apply on the faulty screw (remove ALL layers that is held by it).
-A little bubble on the screw and inside the core hole.
-TIP: don't apply on the plastic, it will tighten. also remove screw from centerpiece before applying it
you may replace tiles with cubesmith ones, but not worthed
remove caps adjust tension
Lube and break in.
here's the problem with screw/core
the screw unwinds itself.
go to home depot or other hardware store. buy the most EXPENSIVE threadlocker.
USE BLUE threadlocker.
apply on the faulty screw (remove ALL layers that is held by it).
-A little bubble on the screw and inside the core hole.
-TIP: don't apply on the plastic, it will tighten. also remove screw from centerpiece before applying it
you may replace tiles with cubesmith ones, but not worthed