DIY 2x2, mini DS or mini c?

Cool, thanks. And also, where can I find a guide on how to do this?
It's pretty easy to figure out, but somewhat difficult and time consuming to do. WARNING: You are in deep **** if you don't have a dremel!

First, you sand down the centres. Then sand down the edges as if you were going to make an octobarrel, but do it with all edges. Then, assemble a 2x2 block (1 corner, 3 edges) and glue it together (If you look at an ES 2x2 core, you will know what I mean). Then, hollow out the 2x2 corners. Assemble the DS (now with modded centres and edges) and glue on the "corner caps".

That is the best explaination I can give.

I finally finished, so far it isn't much better than my ES was. I think that with a bit of playing with tension and lube, it may get better. :)
 
Back
Top