stackmat analysis mode

Stefan

Legend
Joined
May 7, 2006
Messages
7,286
WCA ID
2003POCH01
YouTube
Visit Channel
Something that just came up on the German forum (here)...

I have the stackmat with the memory and data port, not sure it's exactly the same for all.

1. Turn your stackmat on.
2. Press and hold the power button (so the timer turns off)
3. Press the reset button four times.

Now I see all display elements displayed. At this point you can stop holding the power button.

Pressing reset now cycles through four stages:

1. No light on, display shows about 0308.
2. Red light on, display shows about 01F2.
3. Green light on, display shows about 01F2.
4. No light on, display shows about A4A4.

The numbers change slightly and depend on where I put the timer. Putting my hands on the sensors reduces the numbers. Hovering over the sensors also reduces them a bit. The largest distance where I could see a reaction was about 8-9cm (about 3-3.5 inches).

Pressing the power button at any time turns the timer off.
 
Last edited:
Interesting this could be useful in measuring timer sensitivity to QC comp timers.
Also I don't get 1 or 4 only 2 and 3.
 
I have 4 stackmats here with memory and port.
Two of October 2005 don't have this.
One of September 2007 and one of January 2008 have it, but I can only cycle though green and red.
 
Do I have the oldest running timer in the community? June 2005 it says :P

Did not work :(

The numbers change slightly and depend on where I put the timer. Putting my hands on the sensors reduces the numbers. Hovering over the sensors also reduces them a bit. The largest distance where I could see a reaction was about 8-9cm (about 3-3.5 inches).

It's probably an Ohm metre that mesaures the resistance over the pads, if it is low enough it will OK it.
 
Last edited:
Stefan, I remember you taking your timer apart a few months ago, are you able to tell me if the touch pads just work via capacitors? If so this could represent the change in capacitance, but Kenneth's idea is pretty solid as well.
 
Last edited:
Nice discovery. We should check the numbers for some faulty timers.
It might even be possible to adjust the sensitivity of the pads.
 
My stackmat is November 2007. I can only swap between green and red. On red the number starts as 0235, on green 0232. By putting my hands near or on the sensors the numbers go crazy. On red the lowest I can get is 01d1, on green 01E4. This is achieved by pushing down as hard as possible.
 
My stackmat is October 09.

On red, it starts on 0252 and for green it starts on 021E.

Tilting the stackmat in different directions displays different things as does pushing on the touch-sensitive pads. I can only cycle between red and green.
 
Stefan, I remember you taking your timer apart a few months ago, are you able to tell me if the touch pads just work via capacitors?

Sorry, I don't know what capacitors are (electronics newb here), maybe you can tell by looking at my pics again ([thread=19395]here[/thread] they are)?
 
I just noticed that when the redlight is on putting only by left hand down does nothing (but putting both or just right changes the display), similarly for green my right hand alone does nothing.

Anyone else have this happen?
 
Back
Top