Problem With F-II Caps

RaresB

Premium Member
Joined
May 8, 2010
Messages
687
Location
Canada
WCA ID
2011BOST01
YouTube
Visit Channel
I recently got an f-ii and had some bad experiences with the caps. The caps on the cublets always fall off while solving. I was wondering how I can fix this without harmining the cube. Do not just say glue them because I am always afraid to do things by myself so I need like step by step of what materials to use and what I need to do.
 
How do you expect to fix it if you're not going to do it yourself? Honestly, a small drop of superglue should be fine. But okay. Step by step it is.

1. Put cube on table.
2. Get superglue.
3. Get cap.
4. Open superglue and put a small drop on the cap where it will come in contact with the cube.
5. Put the cap in.
6. Wait for it...
7. Use cube.

It worked for me.
 
There aren't any steps... you just get the glue and glue them... it can be hard to get them out but you can just do it when they pop out. I have had the same problem. But it's only because I do OH with my cube and I keep dropping it on pavement. DX it's cracked in places on the inside... but it still works great. I'ma just going to get a new one and be careful with it. But yeah...
 
DO NOT UNDER ANY CIRCUMSTANCE GET ANY GLUE ON TO THE SPRING OR THE SCREW. YOU WILL RUIN YOUR CUBE.
 
Ok now how about glue gun

dude, if you use a glue gun, your cube will die. don't. seriously, it will screw up your cube and it will suck FOREVER. don't use superglue either. It will also make your cube so stiff, you can't move your cube. The only way is to mix your saliva with some bubble tea, and put it in the microwave for 30 seconds. Then take it out, stir it, then microwave for 30 seconds again. repeat 12 times. EXACTLY 12.

SARCASM, calm your pants!
 
1 pop cube
2 place core far, far away from the superglue
3 cubie by cubie:
- pop cap off (you can push it out from the back)
- apply a tiny drop of superglue on the inside rim of the cubie
- place cap back on
4 reassemble cube

If you do not dare to use the superglue bottle directly on the cubies:
1 take a paperclip
2 fold it open
3 place a few drops of glue on a solid surface
4 dip an end of the paperclip into the superglue
5 transfer some glue to the cubie (or cap)

You may also consider using a more viscous superglue type to reduce the risk of unfortunate joining events.
 
I couldn't be bothered glueing so I just cut some paper and put it between the cap and where it goes into the cube, to tighten it. It's working fine so far.

You couldn't be bothered to use a little glue, but you could be bothered to get out paper, cut it into the exact size pieces, and then go to the effort of getting it in under the caps without any paper showing?

I think glue would be much easier.

(btw I used glue).
 
Back
Top