DIY help?

Tain

Member
Joined
Apr 2, 2009
Messages
21
i recieved my DIY in the mail yesterday, and adjusted the tension.

it turns much better than a rubik's cube, but isn't nearly is good as the ones i see on videos, do i need to break it in, or lubricate it, or is my tension wrong?
 
Maybe all three? But definitely break-in and lube. What in particular do you see in a video that makes you think that your cube is not as good?
 
What type is it? And what type did you see in the video? Are they the same type of DIY? Give it some time, it will get better, lube it, break it in, and get the tension to your liking and you should have a very nice cube :)
 
ok, yea i knew from the beginning that they were using a different type, but anyway, i was just simply asking if you did those things to a diy? so thank you.. i just didn't want to mess it up by trying to break it in, or lubricate it.
 
to answer ellis, mine like feels smoother than a rubiks, and definatly the corners are better, but it is hard to turn, and i always see people misaligning theirs without it popping. depending on my tension i can either make it turn fast, or not pop..
 
ok, i will, i just wasn't sure if it wasn't 100% if it was still worth it
 
oh, ok..

should i wait to apply the silicon, or does breaking it in first matter?
 
I personally don't think it matters too much, although others would disagree with me. Just do a good number of solves and then lube. If you don't have the silicone now, then thats fine, just solve the cube and lube it when you get the lube.
 
Like I said, I don't think it makes that much of a difference. Break it in a little, do some solves. As long as you aren't applying the silicone like immediately after you assemble it.
 
For breaking the cubes in....would 100 solves be enough?? I have like 5 new diys that needs to be lubed (just got my crc silicone today) and 3 of those I did like.... maybe 2 solves on each of them.
 
For breaking the cubes in....would 100 solves be enough?? I have like 5 new diys that needs to be lubed (just got my crc silicone today) and 3 of those I did like.... maybe 2 solves on each of them.

People say that 100 is a good amount. I don't think that much is necessary. I usually do like 25-50, but I don't even think doing that much is important.
 
None of the silicone sprays are actually 100% silicone.
that's not quite true... I use 100% for my Rubik's cubes and it works very well.
i challenge you to find commercially available "100% silicone" check your lube again and look for any petroleum based ingredients. sprays have distillates which are used as propellants btw.

edit: ellis basically beat me to the punch
 
Back
Top