I "screwed" up

Ikaruga102

Member
Joined
Feb 26, 2009
Messages
18
Location
Phoenix
On the yellow side, I overturned the and I think I ruined the threading. It still screws in a bit, but it is still a bit loose for me. How can I fix this? I don't feel like using epoxy.
 
I don't feel like using epoxy.
Why not? I've never actually used epoxy but you're probably going to have to use something in there to be able to get the screw to hold. I had a similar problem that was not as severe and I just used superglue, waited for it to dry, then screwed it back in. It worked fine for me, but like I said, it wasn't as severe. If you really don't want to use anything you can either 1) get a new core, or 2) get a new cube.
 
Could I put like a fatter washer? or somehow adjust the spring?

I don't think so... your problem is with the screw not holding. You don't want that side to turn noticeably different from the rest. Using superglue/epoxy/loctite will only get the screw to hold, which is what you want. It won't prevent you from further adjusting the tension, if that's what you're worried about.
 
no my problem is after a certain point the screw just doesn't screw in because I ruined the threading. It is still a bit too loose for my taste.
 
Now I'm confused... It's loose just because you can't screw it in all the way? Can you actually take apart the cube and look into the core to see what's causing that? If you messed up the threading in the core and there's some blockage inside I would think would have to work something small and thin in there to try and clear it up, like a nail or something. When someone says they screwed up the threading I automatically think that means that it's partially stripped, but that isn't what you mean? Maybe try another screw that's shorter.
 
Back
Top