How can i clean a stickered cube?

[pyrapyravince]

I have a gan 356 air master, and i want to know how i can clean it.

 

[qwr]

clean outside or inside? how dirty is it? for my stickered cubes, which I keep in good condition, to clean the outside you just wipe with a damp cloth.

 

[pyrapyravince]

clean outside or inside? how dirty is it? for my stickered cubes, which I keep in good condition, to clean the outside you just wipe with a damp cloth.

inside

 

[Spifflet]

inside

Generally just soaking pieces in a bowl of hot water and dish soap isn't going to effect the stickers in any way, I've had some troubles with old Moyu cubes stickers adhesive losing some of its stick but you aren't gonna have a problem with new cubes. Just let them soak for like 5-10 minutes and you're basically golden, wipe them off with a towel after or let them drip dry.

GL!

 

[qwr]

inside

same idea. disassemble and wipe down. if it's too dirty, try gently washing or using something gentle like windex. You can wipe down the screws and springs too but try not to get too much water on them.

 

[JohnnyReggae]

I use unscented wet wipes to clean out the inside of my cubes. Works very well. Soaking pieces in water just makes them hard to dry out totally and is way more time consuming.

 

[Scriv58]

I disassemble the cube, clean the internal sides of each piece with a toothbrush lightly dipped in alcohol, and dry each after brushing it. This allows me to clean each track with precision, and the pieces do not get drenched or soaked. Works for me.

 

[SH03L4C3]

I clean the inside with a q tip

 

[MJS Cubing]

I clean the inside with a cotton stick.

A Q-tip? I would use a toothbrush instead.

 

[qwr]

there should be a FAQ thread for this

 

[Elly]

Get a towel or toilet paper, put it a bit of water and clean the pieces with it, then get a dry toewl and dry it and finally lube it.