Vulosity
Member
Well, I was just disassembling my cube to clean it and and I noticed that the corners were "bumpy".
So, I took the wing edge piece that went under it and saw how the corner worked.
The piece actually "shifts" from one bump on the corner to another (the adjacent one). (The edge rests on the middle bump and shifts to the other).
This is what makes the outside layer unsmooth as the inner slices. Try turning the outside layer sloooowly and see for yourself.
So, I thought that if you were to sand the corner's bumpy area and make it smooth, I think that the turning would be smoother. The cube should not pop more than usual.
MeMyself&Pi made a video of the mod:
So, I took the wing edge piece that went under it and saw how the corner worked.
The piece actually "shifts" from one bump on the corner to another (the adjacent one). (The edge rests on the middle bump and shifts to the other).
This is what makes the outside layer unsmooth as the inner slices. Try turning the outside layer sloooowly and see for yourself.
So, I thought that if you were to sand the corner's bumpy area and make it smooth, I think that the turning would be smoother. The cube should not pop more than usual.
MeMyself&Pi made a video of the mod:
Last edited by a moderator: