Screws Loosen During Speed Solves

I have reduced it to that the screws have some glued themsleves to the centre piece. Have you sprayed it with Jig-a-loo? To fix this, try unscrewing the whole centre then try detatching the screw.
 
I have tried taking out the screw and cleaning it, hoping for better results. However, the outcome was the same. I was thinking about gluing the screw onto the core, but I still want to be able to set the tensions.
 
The same thing happened to me. The thing you need to do is take out the screw, add a drop of glue at the end of the screw and then screw it back in. Don't put too much though. After that it shouldn't move and anymore and if you do want to tighten or loosen it, when you pu the glued screw in, screw it in really fast to the tension you want. You should still be able to adjust it after putting the screw it, it's just a little rougher to turn but it still works.
 
I had the same problem, Loctite the center of the core (a drop or 2) and put the screw back in. The glue will cause friction in the threads. I did this a a couple of months ago and I never had a problem with my 5x5 since.
 
Back
Top