Recent Problem With My Cube

soccerking813

Veteran
Joined
Jan 27, 2009
Messages
735
Location
North Carolina, USA
So, yesterday my cube was sucking really badly, so I took it apart and wiped off all the cubies. When I put it back together, it worked really well, so I started timing some solves. After about 10 solves though, the cube got really slow and tight, so I lubed it again. This made it very good, and left it for the next 40 or so solve. But this morning, I started another session, and it was feeling really sticky and bad, so I wiped all the cubies again. It felt pretty good. Then I did a few solves, and it started getting tight and slow again, so I lubed it. And once again it worked very well.

Tomorrow the same cycle will probably happen. Just wondering if anyone could possibly give my advice on what to do about this, because it wakes a while to wipe it down.
 
What are you lubing it with? Assuming Silicone, are you lubing it the "take it apart, lube it, let it dry overnight" method? Or are you just spraying it in there? Lubing using the first method works better. If you're lazy, then spray a good amount in there, move it around a bit(to spread it), and take it apart and let it dry overnight. It works WAY better when you let it dry completely, versus letting it sit for 5 minutes.
 
No, I cannot get any sort of good lube here, so I had to experiment with some different stuff a while back. The best I could find was chap stick, which is pretty much vaseline.
 
Soap, graphite, or wax works temporarily (in that order). Wood Varnish makes the cube very loud (you can hear that clicky stuff when you push two layers together) and is only a bit sub-silicone (don't know how long it lasts, though).
 
Well, I guess my situation is pretty weird. I pretty much cannot get anything that is from another country here, unless someone comes to visit me and brings it. And I pretty much cannot get anything here. So I'm stuck with what I have right now until I go back to the US over the summer. But suddenly after being in my pocket for a few hours, my cube turns very nicely.
 
wood varnish.

are you sure thats what you meant? varnish dries hard, not great for a cube

I read somewhere they were silicone based.
It was something like, wood polish, or varnish, or something rather.

I think you may be confusing wood varnish with furniture polish, two VERY different things. I'm not sure if all furniture polishes are the same, but the one I've used (Mr Sheen Multisurface) says it "contains silicones" and works fairly well. Wood varnish contains petrochemical solvents such as white spirit and so would cause damage if not left to dry. Even if left to dry, I don't imagine it would be the best form of lubricant :rolleyes:
 
What are you lubing it with? Assuming Silicone, are you lubing it the "take it apart, lube it, let it dry overnight" method? Or are you just spraying it in there? Lubing using the first method works better. If you're lazy, then spray a good amount in there, move it around a bit(to spread it), and take it apart and let it dry overnight. It works WAY better when you let it dry completely, versus letting it sit for 5 minutes.

Erm...why can't you just lubricate it a bit and then play with it? (ew)
 
I say get another cube and clean your old cube with water and wipe it down. and then try and turn it. see what happens. On the you cube try lubing it and see what happens, if it slows donw like your toher one. If it doent then its proboly the cube.
 
Back
Top