How to use CRC?

Cuberty

Regular
Joined
Oct 30, 2011
Messages
79
Feel free to post your stories and answer any question(s).

1. Which type of CRC should I use?

2. How should I apply it?

3. Does it melt plastic?

4. Should I work it in, then leave it for some time?

5.How much should I apply?
 

Just to answer how much you need to use when it comes to aerosol lubes. Not that every aerosol lube is identical ima...

Btw. : what appear to be fast-forwarded parts of the above vid are actually "real time". The parts where "Bad" seems to be talking "normally", were slowed down so that us mere mortals can follow...
 
Last edited by a moderator:
Hello! Here are what you should do.
#1 In Canada I can find jigaloo in Walmart.
#2 With jigaloo i find applying it to a cotton swab and turn the middle layer 45 degrees and rubbing it on the sids of the cube
#3 If you drowned the plastic yes.
#4 I find maybe doing 10-15 sloves, Jigaloo is somewhat stinky ( I don't like the smell ) but I let it stand for maybe an hour.
*5 Dont use too much! yo;; melt the plastic! I usea bout a little spray! remember don't use too much! ~ Happy Cubeing!
 
CRC does melt the cube if you put a lot in. Only put a short squirt in. Use the "Heavy duty silicone spray" stuff. Just put the tube between 2 layers and depress the button for a quarter second. Enjoy your super fast cube!
 
1. CRC Heavy Duty Silicone Spray, in a red can.
2. Pop out one edge, spray for about a second, maybe less, put the edge back in.
3. CRC itself doesn't, but the propellant does just a bit.
4. After you spray it in, make sure to work the lube in, turning all six sides to make sure it gets spread evenly. Turn randomly for 20-30 seconds, then do a few solves. Don't let pieces "stick" together: this might happen right after you spray it in, but as long as you work it a bit, you'll be fine.
5. See #2
 
Back
Top