super_speler
Member
- Joined
- Feb 5, 2010
- Messages
- 11
After learning to solve it for the first time, I decided to lubricate my cube with Vaseline (*gasp*). Despite all the warnings, it did in fact help the cube move faster and smoother. All in all, I was happy with what I had. It might have been just me, but after a while, it started to turn slower and felt really rough in general. I decided to clean out my cube to try and alleviate the problem, but that only resulted in a cube just as bad as when I first bought it.
Finally giving up on trying to even turn the thing, I went out and bought a can of CRC Heavy Duty Silicone, due to its apparent popularity in the cubing community. After reading about lubrication using CRC and watching a few Youtube videos, I finally got to actually lubing my cube.
Copying badmephisto in his video, I popped two edges, sprayed in the CRC (two quick bursts each), popped the edges back in, and started to work it in. But then..
At first, turning it was pretty normal. However, the next few turns, it started to feel like I put glue in the cube - Turning it required tons of effort. Not only that, but below it, black specks started falling out of my cube, which I'm sure isn't the best thing for it. Too late to turn back, I just kept on working the CRC in and after a while, it began turning smoothly and faster than before.
I was satisfied with the end result, but disassembling my cube again, I found that the inside was pretty much devastated. Scratching the plastic scraped it off, and it was just plain ugly. The core is the only part that didn't seem to be affected.
My question is, is this normal? If I get new cubes and decide to lubricate them with CRC, will it have the same effects? Because given the popularity of CRC, I was hoping for something a bit, say, cleaner.
Finally giving up on trying to even turn the thing, I went out and bought a can of CRC Heavy Duty Silicone, due to its apparent popularity in the cubing community. After reading about lubrication using CRC and watching a few Youtube videos, I finally got to actually lubing my cube.
Copying badmephisto in his video, I popped two edges, sprayed in the CRC (two quick bursts each), popped the edges back in, and started to work it in. But then..
At first, turning it was pretty normal. However, the next few turns, it started to feel like I put glue in the cube - Turning it required tons of effort. Not only that, but below it, black specks started falling out of my cube, which I'm sure isn't the best thing for it. Too late to turn back, I just kept on working the CRC in and after a while, it began turning smoothly and faster than before.
I was satisfied with the end result, but disassembling my cube again, I found that the inside was pretty much devastated. Scratching the plastic scraped it off, and it was just plain ugly. The core is the only part that didn't seem to be affected.
My question is, is this normal? If I get new cubes and decide to lubricate them with CRC, will it have the same effects? Because given the popularity of CRC, I was hoping for something a bit, say, cleaner.