Question about CRC

kratos94

Regular
Joined
Aug 14, 2008
Messages
99
Well i used Heavy Duty CRC silicone and well ive noticed that it looks like it melted my cubies to a certain extent. Its not that badly melted but it looks coarses and definetly slightly deformed.

Edit: srry im sorta brain dead after doing a bunch of WH2 Alg 2 and Bio HW so yeah....
What exactly happened to my cube? and is it typical?
 
Last edited:
Well, the propellant in CRC (and every silicone spray) is some form of petroleum. When you lubed it, did you keep solving the cube and spreading the lube around within the cube until the lube dried? That would keep things from becoming deformed or stuck.
If you did leave it with the lube drying, then yes, the propellant can dissolve the plastic a little and act as a cement. I wouldn't be too worried but your cube may feel like it needs to be broken in again. I don't think there's any issues beyond that as long as they aren't too deformed.
 
CRC corrodes your cube.
If you want to use CRC, take out all the pieces and spray, leave it until the CRC totally dries up, then put the pieces back together and play.
It is less corrosive when dried.
 
This has never happened to me. I believe, though, that it happens when you don't mess with all the sides of the cube for about 2-4 minutes. I'm just guessing, but I hope I helped (>^.^)>
That's probably because you didn't apply too much. Just don't spray for more than 3 seconds in the entire cube and you'll be good.
 
Maybe you applied too much. A little goes a long way with silicone sprays. No need to coat every surface with a layer of spray. Next time just spray a little, let it mostly dry, and spread it around the cube.
 
Well, the propellant in CRC (and every silicone spray) is some form of petroleum. When you lubed it, did you keep solving the cube and spreading the lube around within the cube until the lube dried? That would keep things from becoming deformed or stuck.
If you did leave it with the lube drying, then yes, the propellant can dissolve the plastic a little and act as a cement. I wouldn't be too worried but your cube may feel like it needs to be broken in again. I don't think there's any issues beyond that as long as they aren't too deformed.

That's what I've heard that the propellant is what causes the melting. Did you shake the can well before spraying?
 
>.> Regardless of whether he shook the can or not, the propellant is going to come out with the silicone.
 
You could get a 'gob' of propellant on a cubie if you don't shake the can which would cause noticeable melting.
 
Back
Top