Need GuHong Help, Odd Problem?

dabest2500

Veteran
Joined
Jan 14, 2011
Messages
311
I lubed my GuHong already with Lubix, the core and the edge piece.
But the cube pops so I tightened it, now it locks annoyingly and still pops.
Any help here?
Thanks.
 
Overlubing might cause pops if your cube was loose or is worn out.
Tightening it too much will potentially cause lockups.
You may want to play with the tensioning a bit more. How old is your cube and how much use has it seen?
I recently got my MF8 Legend and it was hell getting the tensioning correct.
 
I've had it since mid January.
I'll play with the tensions a bit.
I've used it a lot to learn Fridrich.
Still learning all PLLs (two algs left, both N Perms).
Not learning all OLLs though.
 
I followed the instructions on the Lubix site, in the core and on one edge piece.
I think it's the tensions, the white side is looser than the other sides.
 
Yeah, to make everything even, should I tighten it to the maximum, then loosen it the same number of turns for every face to ensure the same tension?
 
What I tend to do is >

- Take out all of the corners and edges.
- Take the core with centers still attached, pull the center pieces away from the core one by one and adjust the screw for each until you can see about 0.5mm of screw between each center and the core. (make it 1.5 for the MF8 Legend, otherwise you won't get the pieces in).
- Reassemble the cube.
- Now you have approximately the same tension on each side.
- Now solve the cube and tighten/ loosen the screws by a half turn each until the desired handling is achieved.
 
Almost an hour later since my last post.
Getting the tensions perfect was a long job, but my GuHong is really good now, thanks very very much for your help :)
Not a single pop yet (touch wood :D ).
 
Almost an hour later since my last post.
Getting the tensions perfect was a long job, but my GuHong is really good now, thanks very very much for your help :)
Not a single pop yet (touch wood :D ).

So glad it worked out and that you can get back to practicing again. As said; it can be a b*tch to get right, but it's rewarding when you do nail it.
It could still pop sooner or later, but GuHongs may do that now and again. Depends on your turning style among other things.
 
If it pops I can just tighten is half a turn to fix it right?
And how long before I need to replace the GuHong?
 
If it pops I can just tighten is half a turn to fix it right?
And how long before I need to replace the GuHong?

Sure, you can try that. But even when you reach the optimum settings for your cube and your style, those settings will probably still be a compromise between "popping" and "too tight". Even the best cube can pop if you manhandle it too much.
 
Last edited:
Back
Top