One-Answer 2x2x2 Question Thread

How can reverse corner cutting for 2x2 (such as Weipo) be improved? Lube?
I tried loosening but it makes the cube too unstable
 
Are there better PLL algs for 2x2 than the usual T-perm/J-perm and Y-perm? I dont really mind the t/j perms but the Y perms get me sometimes
T,A,J,Y perms all accomplish the same thing (adj swap)

My questions:
So my previous pi OLL alg was R' F R2 U' R2' F R but this swapped the bottom layer front corners which I thought was bad for keeping track of bars, so now I use F (sexy)2 F'. Was this a good switch?

Also is there any reasons to prefer (R U' R' U') F2 (U' R U R' U) F2 over (R U' R' U') F2 (U' R U R') D R2 for diag swap pll? My execution for both is about the same but my F2 moves are sloppy.
 
Y does diag swap. Also, would recommend R' F R F' R U2 R' U R U2 R' for adjacent.
1. It was an ok switch, but I would recommend R' U R2 U' R2 U' R2 U R' instead.
2. I would recommend the second one, but it doesn't matter too much.
 
Hey everyone,

I recently got a 2x2 a few days ago and now I average about 12 seconds, as I found that many 3x3 algs transition to 2x2. However, when learning PBL algs for 2x2, I came across this case which I could not figure out how to solve. I solved red first, then orange on the top. I tried using the alg R U' R F2 R' U R' but it did not work. How would I solve this case? Also, one more question, do some PBL cases require you to flip the cube upside down to solve them?

Thanks.

IMG_1367.JPG
IMG_1366.JPG
 
1. No, there should never be a need to rotate the cube to do PBL.
2.You need to align the white bar in the bottom layer with the blue bar in the top layer.
3.Ask these kinds of questions in mega threads. Don’t create a pointless thread like this because you’re too lazy to go the already existing posts.
 
Back
Top