x-cube question.

Probably about a thousand solves + having to re-lube/clean it out twice. It takes a lot of work.

When you get it (i assume as a DIY, if not just disassemble it) lube the core from izovires video on youtube with lubix. Then before you assemble it spray D39 (or CRC) on the pieces. Assemble. Do aboutt 2 solves to spread the CRC around + lubix. Put maru in the outer layers. Do 100 solves. Clean out cube. Do 900 more solves then it should be good

Also, make sure you cut the excess plastic off the pieces etc etc
 
Last edited:
Also, make sure that you tension it properly! This cube is an absolute disaster if you haven't properly tensioned it. When you spread apart your centers after the cube is assembled the screws should be in the center of the core. If not you have to do some adjusting on that center and the 3 around it in order to make it centered. Tensioning took me about 2 hours, but even without me x-cube being fully broken in it's still a dream to use because the tension is so good.
 
I need to order 2. I can't seem to find them anywhere anymore. Maybe I just didn't look enough. Does hknowstore still have stock? I heard they were sold out :|

Anyway, If someone could post a link, It'd be helpful. I'm feeling rather lazy :D
 
Mine took about 2-3 days to break in, nearly 50 solves and it already was impressive. 100 Solves, inner layers started moving smooth, outer layers were orgasmic.
When you first assemble it you'll notice that it's quite stiff. But don't panic, it'll get better over time.
And yeah, lubix is necessary.
 
Last edited:
Probably about a thousand solves + having to re-lube/clean it out twice. It takes a lot of work.

When you get it (i assume as a DIY, if not just disassemble it) lube the core from izovires video on youtube with lubix. Then before you assemble it spray D39 (or CRC) on the pieces. Assemble. Do aboutt 2 solves to spread the CRC around + lubix. Put maru in the outer layers. Do 100 solves. Clean out cube. Do 900 more solves then it should be good

Also, make sure you cut the excess plastic off the pieces etc etc

what about if i don't have lubix, should i proceed with normal silicones?
 
Back
Top