What is the best cube for cutting corners and that has speed. (Hybrid is fine)

[Gazzdog]

I really have been researching this and wanting to get this perfect cube.

 

[Novriil]

I really have been researching this and wanting to get this perfect cube.

http://www.speedsolving.com/forum/showthread.php?t=12659
check that out.

There is no BEST CUBE. There are personal favorites. Everybody don't turn the same way.

 

[daniel0731ex]

type c cuts corners better than any other cube, and is really fast

 

[miniGOINGS]

Does the Type C have raised center caps?

 

[daniel0731ex]

Does the Type C have raised center caps?

the center cap stays on nicely

 

[JTW2007]

The Type C does not have raised center caps, nor does it cut corners better than any cube. In terms of corner-cutting, the old Type A, the C4Y diy, and the Type F are the ones that come to mind. When it comes to speed, C, Type A third model, and Type D come to mind.

 

[daniel0731ex]

The Type C does not have raised center caps, nor does it cut corners better than any cube. In terms of corner-cutting, the old Type A, the C4Y diy, and the Type F are the ones that come to mind. When it comes to speed, C, Type A third model, and Type D come to mind.

the c4u sucks at cutting corners:confused:

 

[JLarsen]

The Type C does not have raised center caps, nor does it cut corners better than any cube. In terms of corner-cutting, the old Type A, the C4Y diy, and the Type F are the ones that come to mind. When it comes to speed, C, Type A third model, and Type D come to mind.

the c4u sucks at cutting corners:confused:

Yeah kinda. It can cut, but it locks up so much it basically doesn't cut.

Old type a mostly comes to mind for corner cutting.

 

[elcarc]

The Type C does not have raised center caps, nor does it cut corners better than any cube. In terms of corner-cutting, the old Type A, the C4Y diy, and the Type F are the ones that come to mind. When it comes to speed, C, Type A third model, and Type D come to mind.

the c4u sucks at cutting corners:confused:

i must have gotten the perfect c4u cube. mines cuts corners at almost 45 degrees

 

[Edmund]

My Diansheng is crazy fast but doesn't cut corners too well. My old a is great at cutting corners but isn't fast really. I don't know but I hear Edison's are good and so are F's.

 

[daniel0731ex]

my void cube is AWSOME at cutting corners

 

[Truncator]

My Old Type A can cut over 45 degrees with fairly loose tensions. I only get pops every ten solves or so.

 

[elcarc]

my void cube is AWSOME at cutting corners

but dash imposibabler

 

[tfkscores]

My edison can make amazing cuts on even a really tight tension and its pretty fast after broken in.

 

[JTW2007]

My Old Type A can cut over 45 degrees with fairly loose tensions. I only get pops every ten solves or so.

YouTube or it didn't happen.

 

[waffle=ijm]

around 35-40 seconds will show how much it cuts corners

 

[Truncator]

My Old Type A can cut over 45 degrees with fairly loose tensions. I only get pops every ten solves or so.

YouTube or it didn't happen.

Actually it's exactly 45

I'll see if I can bother getting my camera out.

 

[panyan]

i dont think c4u cuts corners that well either...

 

[Gazzdog]

Can any one direnct me to where i can get an old type a or a type c please.
thanks

 

[Cride5]

eBay..