What happened to my Gan 11 M pro?

Discomantis

Master
Joined
Jul 13, 2022
Messages
1,787
Location
New York City
WCA ID
2022ROGE05
YouTube
Visit Channel
So yesterday I was setting up my Gan 11 M pro, I had just swapped out the light blue nut for the dark blue nut, and I was doing some turns algs on it (I was doing the sussy U perm which is kind of funny) and the cube exploded and four pieces came out as well as the blue nut and the clear piece surrounding the nut. The top center is now not locked in place, and I can pull it a long distance which makes that side unstable to the point where if I try and turn the cube every piece on that side just falls off. After tugging on the other centers to see if they had the same issue, they all seemed fine until they all gradually got the same issue after a few minutes of testing those centers! Does anyone know what happened and how I can fix this?

EDIT: I fixed the issue thanks to Garf. If anyone else has this issue, speedcubeshop has a video called "Is your Gan 11 M Pro falling apart" which is very helpful.
 
Last edited:
Maybe don't use that nut or like tighten that center a little more than the others? Hope this helps
 
So yesterday I was setting up my Gan 11 M pro, I had just swapped out the light blue nut for the dark blue nut, and I was doing some turns algs on it (I was doing the sussy U perm which is kind of funny) and the cube exploded and four pieces came out as well as the blue nut and the clear piece surrounding the nut. The top center is now not locked in place, and I can pull it a long distance which makes that side unstable to the point where if I try and turn the cube every piece on that side just falls off. After tugging on the other centers to see if they had the same issue, they all seemed fine until they all gradually got the same issue after a few minutes of testing those centers! Does anyone know what happened and how I can fix this?
You need to make sure the tension for the blue nut is NOT on the removal setting. And make sure that the ends for the core (where it attaches to the nut setting) are not broken.
 
You need to make sure the tension for the blue nut is NOT on the removal setting. And make sure that the ends for the core (where it attaches to the nut setting) are not broken.
Nothing is broken on the core. So does that mean all I would have to do is insert the clear thing and the nut back into the center and change the nut setting to something other than remove?
 
Back
Top