Tension

Status
Not open for further replies.

Mr. E

Regular
Joined
Jul 14, 2008
Messages
26
Hey, I was wondering what i should do to adjust the tension on my DIY 3x3x3 cube. I have been having problems with it sometimes seizing up and when i try to loosen it usually a middle piece pops out. Right now i have the cube lubed with silicone which works quite well i just am getting mad when i have a really good F2L and then it starts to seize up or I have a piece pop out.

Thanks for the responses :D
 
A lot of it depends on what cube you have. For example, rubiks.com DIYs pop easy and need to be set somewhat tight. On the other hand you might have a Type a that can be set lose because it doesnt pop much. What do you have?
 
i have an A class black DIY cube that i bought off cube4you(dot)com
 
If you loosen it more you'll have a smoother cube, but risk popping during a good solve. On the other hand, setting the tension tight will make the faces slightly stiffer, but it will probably pop less. If you think a looser cube suits you better than just try slowing down your solving speed to minimise popping. Hope this helps.
 
ok, thanks for the reply. I have loosened it a bit and it seems to work better. I have just one more question and it is regarding lubrication. Vaseline or silicone?
THX
 
SILICONE!!!!!!! not only will it last longer but vasiline will damage your cube in the long run. despite that you don't need to break it in as long as silicone, its not as effective as silicone.
 
Status
Not open for further replies.
Back
Top