Stackmat malfuntion

vuaquyen92

Regular
Joined
Sep 24, 2008
Messages
82
Location
VietNam
WCA ID
2010PHAM08
YouTube
Visit Channel
I have a little problem with stackmat in a competition
So when the time appear about 0.02 or 0.03, does it call malfuntion or the cuber fault?

I have try to do with stackmat as fast as I can but it always 0.05 or above

any comment?
 
I think a 0.02-0.03 or under means the only possibility is timer malfunction because people can't actually stackmat that fast.
 
Depends on your Stackmat, probably. The older ones can't go lower than 0.05, and only the newer ones (2006-2007 and after) can do 0.02.
 
I accidentally got a 0.03 second timer malfunction in competition, and I got to do the solve again with the new scramble. I think that this applies when you get under 0.06.

Also, when intentionally getting the lowest time on a stackmat, I have got 0.02. :p
 
It is easy to get .02 or .03 on a stackmat when you are intentionally trying. I think in competition it's if you get under a .05 or a .06 you get the inverse scramble.
 
A6b1) If the timer stops earlier than the end of the solve, and the timer shows 0.01 - 0.05 then the solve is replaced by additional solve, unless the competitor intentionally forced the early timer stop (courtesy of the main judge).

A6b2) If the timer stops earlier than the end of the solve, and the timer shows 0.06 or higher then the solve is disqualified, unless the competitor can show evidence that the timer was malfunctioning.
 
Back
Top