ShengShou puzzles and quality control

Have you encountered quality problems with ShengShou puzzles?


  • Total voters
    62
ShengShou screws are just horrible. You might as well throw them away after adjusting them a few times just in case you'll never be able to take them off.
Other than that, I've had problems with the plastic injection once, one of my edge on the mini 7x7 had a dent in it, and I had the whole puzzle replaced by Maru, so that was good.
Still, SS puzzles are awesome.
 
Hmmm... looks like many people have a bit of a bad luck with Shengshou(s). I've got a few myself, and other than a broken washer, its all perfect. Considering the fact that Shengshou sells VERY cheap products, its fine.
For example - 3x3 in India = $4.41 = Rs.274 /- (ONLY)
 
The washers are **** i had one when i took the cube apart the washers were so rough that the springiness when i turned it it when back to the origianl position
 
I only have a SS 5x5, but I'm very happy with it, though I've only had it for a few months. I have not taken it apart to lube it, tension it, mod it, or check the pieces. If I did notice the cubes tension getting off, or something not working quite right, I would check out the pieces, but since there is not, why check? I prefer to break cubes in rather than mod them because you then run the risk of ruining the cube. They also break in faster if you don't lube them because there's more friction. After a cube is fully broken in, I then use lubricant on it.
 
I forgot to say that my SS 5x5's core seem to have cracked a bit, but I've never dropped it. It's still usable though.
 
I only have my SS pyraminx, and aside from the two stripped (and rusted) screws that came with it, it's all fine :/
 
The most problematic thing I've encountered with these products is the abundant ammount of lubrification which in turn goes in contact with the stickers, making most puzzles completely unusable out of the box, before a thorough cleaning process.
 
ShengShou screws are just horrible. You might as well throw them away after adjusting them a few times just in case you'll never be able to take them off.

I just changed the springs in my new mini 7x7. After going through 6 screwdrivers to find the best one I still almost completely stripped the first screw. I finally picked up my Moyu screwdriver I got for free from The Cubicle and although I thought I would be too big, it was a perfect fit!. It worked on the almost stripped screws, and the rest of the screws were removed and reinstalled without ANY marks or stripping of the screw. It looks like we found a solution to Shengshou.... it's... Moyu
 
I just changed the springs in my new mini 7x7. After going through 6 screwdrivers to find the best one I still almost completely stripped the first screw. I finally picked up my Moyu screwdriver I got for free from The Cubicle and although I thought I would be too big, it was a perfect fit!. It worked on the almost stripped screws, and the rest of the screws were removed and reinstalled without ANY marks or stripping of the screw. It looks like we found a solution to Shengshou.... it's... Moyu
Hahah shots fired...

Does anyone have a tutorial on hardware swaps in the shengshou 7x7?
 
Hahah shots fired...

Does anyone have a tutorial on hardware swaps in the shengshou 7x7?

Just disassemble the core and swap the springs, nothing else...
Or were you referring to like a comparison of the performance with different springs?
 
Back
Top