What mod did you do?
Ok, looks like we have the same cube. I did a few different mods, some of which I have no idea how useful they are but you can try them if you want to, and the most important part to mod is the core (you will pretty much have to fully disassemble to do this, which means you will have the fun of putting it back together.)
So, the problem I think is caused by the hidden T-centers catching on the core, specifically the 4 hooks which are there to prevent misalignments. When your cube is disassembled, take one of the T-centers and sit it in place at one of the hooks. Hold it against the center, and turn the center 90'. No problem. Move the T-center down towards the core by 1-2mm, and try to undo the turn you just did. Chances are, the piece will catch. You will want to remove some of the plastic along the edge of the hook, towards the inside where the T-center catches. I wouldn't remove material from all along the edge of the hook, in case it affects the misalignment ability, and it isn't necessary either. You can also remove a tiny bit of plastic from the corner of the T-center, although again you don't want to take off too much.
I also removed some flashing from the X-centers, there was a little dot of it on all of them, it is east to spot and remove. I did a few other things too, but I don't think they did much. If you have properly modded the core (keep doing the test with a T-center turning to make sure it doesn't catch when it is slightly out of place) and you still have some issues with pieces catching when you assemble it, then the other mods I did are obviously more important than I thought and I'll let you know about them. Otherwise, not much point doing extra work for nothing.
I hope that was clear enough, good luck

.