Screws in DIY stuck

Tetris Cube

Regular
Joined
Jan 16, 2009
Messages
125
I want to switch the core, screws, and springs of my type D cube, but two of the screws are stuck spinning in their orbits. The core is cracked in one part, but I got the screw out from where the crack was. They can't be tightened or loosened. How would I get the center pieces out?
 
I could do that, but I was thinking of keeping the core to make a DIY storebought. It's still mostly in tact, just a big crack I can superglue back probably.
 
Use something small in between where it is cracked to pry apart the 2 sides of the core but only enough so you can pull the screw out. Another alternative is to pull and unscrew at the same time and it might come out like that.
 
There's no way pliers could fit in between the screw and the centers. Type D screws are fat, and take up the whole space. I'm probably going to end up breaking the core, but then I have a bunch of pieces to another cube with no core... lol.
 
I can't seem to break the core... I tried prying open the cracks, but I can't get them open, and an X-acto knife just scratches it. I'd try hammering it, but it'd be loud as hell and my parents would ask wtf I'm doing.
 
Ok. I actually had this problem the yesterday. Tried to break the core, but way too hard. What I ended up doing was using a door. So you position the core with the center in such a way so the the edge of the door contacts the gaps made by the base of the center piece and the core. Have the edge of the door frame contact the other side of the gap so that the unit is clamped by its gap by the door and its frame. Next, either close the door slowly. If that's not force enough to jolt the screw out, just slam the door shut lol.
 
Back
Top