Megaminx modding help - 2011

Toquinha1977

Regular
Joined
May 7, 2009
Messages
174
Location
Vancouver
WCA ID
2008YIMV01
YouTube
Visit Channel
Okay, did the forum search...probably could've looked harder, but here's my question. I have an "older" stickered Mefferts Megaminx (bought in 2003) which I painstakingly dismantled with the intent of replacing the screws and springs with the screw/spring/washer combos from Cube4You. I've done this once before with a tiled Mefferts Megaminx (bought in 2007) and it worked pretty well.

I want to go full out with this one and file down the corners and edges, but first step was to replace the screws and springs. Looking to see if I could get the same type-A screw/spring/washer set, I looked on both Lightake and Cube4You and they don't seem to make 'em anymore. So I just went ahead and cannibalized the screws and springs from this cube...

http://www.dealextreme.com/p/diy-3x3x3-brain-teaser-magic-iq-cube-complete-kit-purple-21524

...which seemed to make sense, since it came from Cube4You and all...and then I find out that the screws are too thick to actually fit into the existing core.

So, my actual question...will these fit?

http://www.speedcubeshop.com/apps/webstore/products/show/1531847

I just ask because I don't know if they've changed at all in the three years since I did the mod, so maybe they'll fit, maybe not. All I know is that I don't feel like cannibalizing my original type-As in order to mod my other minx.
 
Back
Top