Lube for Type C

JTW2007

BattsMan
Joined
Nov 29, 2008
Messages
1,591
Location
᠎
WCA ID
2008WARL01
What lube would you use for a C? I'm considering shock oil, silicone spray, or puzzleproz lube/furniture polish.
 
Puzzleproz lube is furniture polish? That seems kind of wierd to me. Also, I would reccomend the shock oil, but only if it is about 70 or higher (type c's need "slowing down" to prevent pops(in my opinion)).
 
It is, (I made the mistake of buying 90 weight) but it seems to me like without an oil that has some "stickyness" to it it will still pop alot and turn even faster with less control (causing more pops). I need some 20 weight shock oil to really confirm that though.
 
Right now I'm leaning toward puzzleproz lube as I think shock oil decreases the responsiveness of my cube and spray leaves residue (increasing frequency of cleaning).
 
I don't lube it.:D
I tried CRC, it's good, but effect is not so noticeable. I usually switch out the edge pieces for type A edges and CRC or no lube. I don't know if that will help you. I tend to turn very slowly unless I get a U perm.
 
Would Jig-A-Loo work? I understand it melts the plastic washers, but couldn't that be remedied by disassembling and spraying the cube? Or taking them out when you spray the Jig-A-Loo in and then putting them back on.
 
I use A washers, so that wouldn't be a problem. I think Jig-A-Loo makes the cube too sticky though and I'm afraid it would actually slow down my turning speed.
 
I'm ordering one now, but DX air shipping takes forever, but when it gets here I'm going to try ACE hardware brand silicone spray.
 
Back
Top