Lock-ups on ES 4x4

Status
Not open for further replies.

MistArts

Master
Joined
Jan 5, 2008
Messages
1,490
I can average around 2 minutes with it but th 3x3 part is usally over a minute because the outer layers are very stiff and can't turn well. I tried unscrewing the screws just a little. But after a solve or two, the inner mechanism starts to loosen up and it's nearly impossible to turn after that.

Also, I haven't tried lubing it because I can't find any silicone at wal-mart.
 
Well, I guess you can't get the best of both cubes(Rubik's VS ES). In my opinion, Rubik's tend to have smoother faces, but pop and lockup more compared to an Eastsheen. I prefer the Eastsheen though, as it's lighter and generally better. At least that's true for my two 4x4x4's. :P
 
Last edited:
Tighten the screws until you feel, that they won´t move any more. You will find the right spot for this. Then break it in. I did once about 50 solves a day, now it is much much better than in the beginning. Just tighten up as much as you can, until you feel the resistance.
Good luck and happy cubing
 
Both my ES 4x4 and 5x5 sucked out of the box - stiff and hard to turn. After some lubing (I didn't want to disassemble them, so I turned the layers halfway and sprayed lube on the exposed inner faces, then worked it in) and a little bit of breaking in they turn quite well.
 
Ive had 2 black ES 4x4s and 1 white one and theyre all incredible, few locks and theyre amazing, my first 2 came really nice, but the white one had to get some lube in it first. (jigaloo ftw)

I disassembled, and sprayed pieces, melting was minimal, since after they melt a little bit on the outside, they dry and become hard plastic again.
(You can assemble an ES 4x4 in around 10 mins, since only the orientation of the corners matter)

With my white ES i avg around 1:25 at home.
 
Status
Not open for further replies.
Back
Top