HELP square-1 parity :|

[lilneo]

ok so it took me like 3 days to get here, fallowing these instructions: http://www.thedryeraseboard.com/mechpuz/square1/solution/ and im on the very last step and it ses that this is a parity, i have 2 edges to be switched without moving the bottom (info on this is at bottom of step 5) and then i gota go to step 2, i was ok with that... until during the algorithm it said:

Turn the right half 180 degrees
Turn the top 90 degrees clockwise
Turn the bottom 90 degrees clockwise
Turn the right half 180 degrees
Turn the top counter clockwise 30 degrees
Turn the bottom counter clockwise 60 degrees
Turn the right half 180 degrees IMPOSSIBLE
Turn the bottom 60 degrees clockwise
Turn the top 60 degrees counter clockwise

the algorithm gos on but no point in posting, can someone provide me with a proper algorithm to fix this parity, even if i have to go back a few steps, as long as it wont happen again

 

[velcro]

http://cubezone.be/sqaure1step5.html

I think this is what yoiu mean. http://cubezone.be/square1step5.html

 

[lilneo]

ok i found the parity on there and tried to do it:
/ (3,3) / (-1,0) / (2,-4) / (4,-2) / (0,-2) / (-4,2) / (1,-5) / (3,0) / (3,3) / (3,0)
[10|26] the bolded is IMPOSSIBLE

nevermind guys, dosnt matter just popped out the pieces and switched, no way im goin through all that again. -.-

 

[masterofthebass]

umm... sq-1 parity takes me about 6.5s now. I use the first EP from cubezone.be, and it's not that bad anymore. Also, lilneo, that (-1,0) is possible, so I don't know what you are talking about.

 

[Swordsman Kirby]

ok i found the parity on there and tried to do it:
/ (3,3) / (-1,0) / (2,-4) / (4,-2) / (0,-2) / (-4,2) / (1,-5) / (3,0) / (3,3) / (3,0)
[10|26] the bolded is IMPOSSIBLE

nevermind guys, dosnt matter just popped out the pieces and switched, no way im goin through all that again. -.-

Well, it's possible. You're just holding it upside down.