Guhong Tensions

[rubikmaster]

I can't set the right tension on my guhong. If somebody has a guhong please tell me what tensions you have on it.Here is how.All guhongs have the screw in the middle,around the screw is the washer and around the washer is that circle,you know,the circle,it's higher than the washer and about the same height as the rest of the center piece.Now you need to loosen all the sides on your guhong until the washers are the same height as the circle.You will need to count how many full turns(360 degrees) did it take you to get to that height.So my question is: Did it take you 3,3.25,3.5,3.75 or 4 full turns to get to that height?So when I loosen my cube to that height,I will know how much I need to tighten my cube from there.If you don't want to,you don't have to do all that but PLEASE,somehow tell me what tension you have on your guhong.Please help.

 

[Reinier Schippers]

Do you have a old guhong or a new one. It depends because new guhong have longer screws

 

[PandaCuber]

Just loosen it. Slowly tighten it till you feel like its perfect for you. For me, i perfer my guhong a little tighter but i never counted how many turns i took.

 

[rubikmaster]

Do you have a old guhong or a new one. It depends because new guhong have longer screws

I have a brand new Guhong.I bought it 2 days ago.

 

[hcfong]

I don't think anyone here can tell you what the right tension is. It's down to personal preference. My advice is keep it the way it is now for a week or so. If you feel it's too tight, that loosen it by half a turn, and if it's too loose, tighten it by half a turn and try again for a week or so. That's what I did.