Whyusosrs?
Veteran
- Joined
- Jul 7, 2010
- Messages
- 494
The 3 pronged plastic piece that connects the corners has broken in my guhong. Both the top piece and the bottom plastic prong piece. Now one of them broke into 3 separate pieces and I managed to remove 2 of the 3 pieces from their slots in the corner. However, 1 is stuck inside the corner, and I can't get it out. The top 3 pronged piece broke into 2 separate pieces. One piece in a V shape and the other piece stuck in the corner and I can't get that piece out either. The V shaped piece is sitting on my desk along with the 3 corner parts.
So is there anyway to put the corner back together? I have superglued it twice in the past but that wears off in two or three days and adds an undesirable feeling to my cube. I think I could make a smaller 3d triangle shape in shapeways. It would fit snugly into the guhong corner. I could then just super glue the corner pieces to the sides of the triangle.
Of course, the cost of the 3d triangle shape could cost more then just buying a whole new guhong... so yea. If anyone has any better ideas, as to how to fix my corner, I'd be all for listening to it. Possibly buy some plastic sheet for the same purpose as the 3d triangle? I don't know :|
Thank you for reading my long, incomprehensible, rambling post.
So is there anyway to put the corner back together? I have superglued it twice in the past but that wears off in two or three days and adds an undesirable feeling to my cube. I think I could make a smaller 3d triangle shape in shapeways. It would fit snugly into the guhong corner. I could then just super glue the corner pieces to the sides of the triangle.
Of course, the cost of the 3d triangle shape could cost more then just buying a whole new guhong... so yea. If anyone has any better ideas, as to how to fix my corner, I'd be all for listening to it. Possibly buy some plastic sheet for the same purpose as the 3d triangle? I don't know :|
Thank you for reading my long, incomprehensible, rambling post.
