Hello all- I'm a newbie here so if my terminology is a bit off, please bear with me.
I just bought a new GAN 356 and out of the box it is very fast. Much faster than my favorite cube, the MoYu AoLong V2. I wanted to slow it down a little so I increased the tension a bit until it had about the same amount of friction as the AoLong.
The difference though, is at that tension, the GAN has a sticky or tacky feel. What I mean is that the surfaces of the cube tend to stick together a bit until the tension is broken and the layers then slide easily over each other. I hope I am describing this correctly. This effect detracts from the smoothness of the feel, and the AoLong does not do this to a noticeable degree.
What can I do to eliminate the stickiness? Do I lube it? At the same time I don't want to make it faster. Or should I just accept the cube on it's own terms and learn to love the speed?
Thanks in advance!
Dave
I just bought a new GAN 356 and out of the box it is very fast. Much faster than my favorite cube, the MoYu AoLong V2. I wanted to slow it down a little so I increased the tension a bit until it had about the same amount of friction as the AoLong.
The difference though, is at that tension, the GAN has a sticky or tacky feel. What I mean is that the surfaces of the cube tend to stick together a bit until the tension is broken and the layers then slide easily over each other. I hope I am describing this correctly. This effect detracts from the smoothness of the feel, and the AoLong does not do this to a noticeable degree.
What can I do to eliminate the stickiness? Do I lube it? At the same time I don't want to make it faster. Or should I just accept the cube on it's own terms and learn to love the speed?
Thanks in advance!
Dave