CRC vs. other silicone

emu

Regular
Joined
Nov 19, 2008
Messages
25
I have used pure silicone to lubricate my cubes, but since I had to order it online, I decided to give CRC a shot.

I lubed it the normal way (pop 8 edges, spray a little in each edge, work it in for 5 minutes). But I immediately noticed while working it in that it doesn't have the usual "sticky" feel of a newly lubed cube. It felt very rough, like there was a lot of friction between the sides. After an hour of drying, it was unchanged. The sides felt like there was some sort of adhesive, almost (I actually had newly applied stickers, though I doubt that was the problem). So I decided to wipe off excess silicone (there apparently was none) and relube it. I did it the way Thrawst teaches (disassemble, sweep spray, dry). But after the cubies dried after the first sweep, I noticed the silicone has hardened on the plastic! So I hurried to scrape off all the silicone, in case it dried further. When I put the cube back together, there was still a LOT of friction.

So what happened? Is this normal? Am I doing something wrong? I would be very grateful for an answer. Thanks.

By the way, it is a type D cube with cubesmith stickers. I've used it for about six months.
 
Thanks. It's a bit counter-intuitive, though, since when I spray on silicone, it stays liquid for weeks, which is why it turns well.

So I guess I'll try one more time and see if it works....

Edit: I just finished, and I must say, the cube is very fast compared to when it was un-lubed. But it is much different from the silicone I am used to, since it produces more friction when I turn for some reason.

Thanks for your help.
 
Last edited:
Back
Top