Center cap won't fit

Pedro

Master
Joined
Mar 17, 2006
Messages
1,743
Location
Uberlandia, MG - Brazil
WCA ID
2007GUIM01
YouTube
Visit Channel
I got some DIYs from cube4you the other day (type A), and assembled some of them...I was putting the center caps on, and, in 2 of the cubes, one of the centers wouldn't "accept" any cap I tried...it was yesterday night, so I just left it there until today...

now, looking again, I noticed that one of the center pieces borders is kinda "arched", making it impossible to put the center cap on

I took a picture: (click to enlarge)


did anyone had the same problem? how did you fix it?
 
That picture is extremely out of focus, so I can't tell if your arrow is pointing towards one of the 4 round bumps on the center, or if you are indicating the face of the center piece that is "arched".

I recommend turning on MACRO mode on your camera *and* taking the picture at an angle that shows this arch that you see. Perhaps someone will have a good observation then.

At first blush it sounds like a manufacturing defect, but I just can't tell from the picture.

Best of luck.

Brian.
 
Back
Top