A look at the Haiyan's Haiyan cube.

I got some cubes from Haiyan today, here are my pictures of the Haiyan cube:
http://speedcubes.net/model.php?model=40

It looks quite surprising, I'm used to cubes getting more and more rounded and it looks the opposite, quite sharp edges. But the edges that matter are nicely rounded and it turns very well. See how close neighboring pieces are with almost no gap, but also see the big gaps in the middle of four pieces, caused by the rounding of the appropriate inner edges:
front.jpg


I also like the molding, precise high quality, nothing I had to cut away and all caps fit perfectly. Reminded me of the c4u DIY when I first got that. The centers appear "shorter", a bit below the edges and corners. But quite possibly I just screwed in the screws too deep, gotta try loosening them.

So all in all how good would you say that it is?
 
So all in all how good would you say that it is?

You had to quote my whole big post to ask that?

I just assembled it and turned it a bit. That feels quite good, but I can't tell yet how it'll be after lubing/adjusting/stickering and some playing.

Sorry I forgot about that. I havent been on here in a longgg time. I should probably get the memory cube if Im going to get a cube though, right?
 
So all in all how good would you say that it is?

You had to quote my whole big post to ask that?

I just assembled it and turned it a bit. That feels quite good, but I can't tell yet how it'll be after lubing/adjusting/stickering and some playing.

Sorry I forgot about that. I havent been on here in a longgg time. I should probably get the memory cube if Im going to get a cube though, right?

I prefer my AII over my Haiyan- memory.
 
I like the Haiyan cube quite a bit. I've noticed that I can keep it quite loose, and it still doesn't pop. In fact, I'm yet to pop mine after about 75 solves, and the cube is very loose. I need to mess with the tension more and see how it feels from there, but so far so good.
 
I like the Haiyan cube quite a bit. I've noticed that I can keep it quite loose, and it still doesn't pop. In fact, I'm yet to pop mine after about 75 solves, and the cube is very loose. I need to mess with the tension more and see how it feels from there, but so far so good.

But don't you just hate how hard it is to get off the center caps?
 
Well, it's not like you're constantly removing the caps if you've set the tension correctly.

Still, that being said, I prefer the caps on the type A-V/Haiyan Memory.
 
I like the Haiyan cube quite a bit. I've noticed that I can keep it quite loose, and it still doesn't pop. In fact, I'm yet to pop mine after about 75 solves, and the cube is very loose. I need to mess with the tension more and see how it feels from there, but so far so good.

But don't you just hate how hard it is to get off the center caps?
I wouldn't say it is any harder to remove the center caps than any other DIY I've used.
 
My Haiyan came today. So far, I'm a big fan! It's very resistant to locks and, like PJK said, it can be set pretty loose without popping. Having said that, I'm actually a little tempted to get my hands on some sand paper and round off some of the inside corners. I think that might prevent the few catches it does get.

But don't you just hate how hard it is to get off the center caps?

Hah, yeah, I clipped one of the centre caps into a centre piece before I'd assembled the cube -half to see how everything clipped in place and half just having fun- and then spent the next five minutes trying to get the darn thing out again and laughing at myself! :D
 
Back
Top