5x5x5 patterns

[sharpnova]

I'm hostile? All I did was directly explain to you how YOU were wrong.
Just as how you were claiming earlier "well, you're wrong" in a very "as-a-matter-of-fact" tone, as if everyone else was wrong and you were the only one right, in a patronizing tone as well I might add.

I fail to see how a simple explanation coupled with a little sarcastic remark is "so horribly rude" as you make it seem, as compared to your personal attacks of "being on meds" or whatever. You'll notice my post has no personal attacks unlike yours, so this begs the question of who is the rude one.

If you'll take a closer look, it only has a detailed explanation, as well as a clickable link on the picture, which contains a very clearly readable fixed version of the link. But I guess you didn't even notice that because you were too hasty to judge it as "a rude post" and thus were too much in a hurry to say "I'm on meds" or whatever.

issue is over.. unless it's important enough to you to discuss in private messages. i'll just say. yes bundat. i know what a face is. thanks for asking

 

[bundat]

issue is over..

Good. I never saw an issue to begin with anyway.
You're the one who is starting one with personal attacks.
All I was doing is explaining.

unless it's important enough to you to discuss in private messages.

:confused:

i'll just say. yes bundat. i know what a face is.

That's good as well.
Because in your earlier posts, it seemed otherwise.

 

[Enter]

I make patterns for all the cube sizes here is the link
http://www.youtube.com/watch?v=q0ocowG5QWE&feature=channel_page

 

[cubeshooter]

5x5x5 Cube in a Cube algorithm?

:confused: What is the algorithm for the pattern Cube in a Cube for the Professor cube? I found RedKB's video on how to do this, but it was confusing and I did not want to write down the algorithms nor rewinding the video.

 

[TDM]

Probably somewhere here, but good luck finding it.

 

[Erik]

You can do this first with outer layers (RUL etc.) and then with inner layers (Rw Uw Lw etc). This works on any size cube to create cube in cube in cube in cube if you like.
U L2 D - R B' R B' R B' - D' L2 U - R2 F2 U2

 

[cubeshooter]

@TDM
looked there, did not find anything

You can do this first with outer layers (RUL etc.) and then with inner layers (Rw Uw Lw etc). This works on any size cube to create cube in cube in cube in cube if you like.
U L2 D - R B' R B' R B' - D' L2 U - R2 F2 U2

Thanks!

 

[TDM]

@TDM
looked there, did not find anything

I couldn't either. Looking at the number of patterns I'd think they probably have it somewhere, but there's just so many to look through...