My lunhui cuts more than 45

[Piebomb]

I did a few mods to my lunhui and it cuts more than 45 degrees there are 180 points on the corners 144 points on the edges 96 points on the centers I might be off on my math a bit and I don't have a camera

On the bottom of the corners I sanded it down(8 points) right above that I rounded the lines (48 points) v-5 corner mod on the second lip thingy and on the first(94 points) in between the bottom and the second lip the vertical lines(72 points) and on the very top there are three spots that look square round those out(24 points)

on the edges 48 point edge mod on the top and bottom lips(96 points) round the tips of the bottom lip(48 points) round the part where the first and second lip meet and the point where the second and third lip meet(48 points) and on the furthest out parts of the edges round that out(48 points)

 

[Owen]

WOAH! AMAZING!

 

[cubernya]

Nobody is going to do 420 points of modding to get a cube to cut the same as a ZhanChi with no mods.

 

[~Adam~]

Mine cuts about 50deg after lubing the Lubix way. It did take me about 5mins but I think it was worth all the effort.

 

[JonWhite]

did i read somewhere that zhanchis don't cut as much as guhongs? while we're on the subject of modding, I rounded out my new zhanchi's corners (specifically the areas nearest the center caps, total 24 locations) and it cuts just as much as my guhong (about 60 degrees).

the reason i'm posting this is because I did some research on zhanchi modding before I modded mine, and didn't come across any such mod that I just described.

 

[Michael Womack]

you mean this mod?

 

[Kirjava]

is there any video evidence of someone doing a 45 degree cut in a fairly quick solve?

 

[Specs112]

is there any video evidence of someone doing a 45 degree cut in a fairly quick solve?

Is anyone actually that inaccurate at turning in an actual solve?

 

[~Phoenix Death~]

Is anyone actually that inaccurate at turning in an actual solve?

Seriously. This.
Who really needs to cut 45~ for each turn during a solve?

 

[MostEd]

again, its not about the amount it can cut, its about the ease of cutting, so if it can do 45, anything less is going to be really easy to cut