Try lubing it (with lubix for best results) then loosen it a bit but not to the point where it pops nonstop. After some break-in, it should get better.
Try lubing it (with lubix for best results) then loosen it a bit but not to the point where it pops nonstop. After some break-in, it should get better.
You should first check if the tensions are even then proceed to loosen it, after that lube it with silicone spray or silicone oil (like lubix, there's cheaper alternatives though) hopefully you will see a difference in corner cutting after that, if that doesn't work then your Guhong is probably a bad manifacture (sadly), try to check for plastic that shouldn't be in the places they are and take it away if that's the case.