Lubing help

linkin182

Regular
Joined
Jan 19, 2011
Messages
64
Location
In front of YOu~~~
hey everyone, im gonna lube my cube with CRC silicone spray but im wondering where do i spray it in the cube? directly at the core? the gap between the core and center pieces?

THx :)
 
Disassemble the whole thing, put each cubie in a line and just spray the silicone across the entire thing. Position the cubies so the stickers aren't in the front so you don't get too much silicone on them.

Then let it dry for like 10 minutes and reassemble it.
Of course you can just pop one piece out and spray it in there and then move it around, but I hear that will make it act as a sort of a glue and is generally not that good.
 
pop a piece and spray in works good (at least for me), just remember to work it in, do random moves until the sticky feeling goes away, and you're good to go :)
 
yea, kinda, since when you just spray it in the silicone hits the core, but mostly the pieces gets coated when you do it, dont bother where you spray, just spray it into the cube, not too much though, about one sec of spray, and pop it back and work it in
 
How to...

Clean the cube first:
  1. Turn a face 45 degrees and pop an edge piece out.
  2. Then disassembled the entire cube.
  3. Get a cloth or some tissue paper and wipe all the pieces clean.

Option A (quick 'n' easy)
  1. Assemble the cube again and solve it.
  2. Turn the white face 45 degrees and pop an edge piece.
  3. Spray a small drop onto the inside of the exposed corners and centre faces.
  4. Put the edge piece back in.
  5. Try to distribute the lubricant by turning the white face a few times.
  6. Repeat for each face.

Option B (slow)
  1. Arrange all the pieces into groups: 12 edges, 8 corners, and the core.
  2. Place each group of corners and edges on a cloth or paper towl.
  3. Make sure all the pieces are nicely lined up with the same face pointing upward.
  4. Spray a little bit of lubricant on each edge and corner piece from the top (avoid getting it on the stickers).
  5. Distribute the lubricant with some cloth if you need to and let it dry for a few hours.
  6. Flip the pieces over an lubricate the others sides (i.e. repeat).
  7. Try to wipe off excess lubricant if it's really sticky and re-assemble the cube.

I'm assuming you're using CRC 808 or the likes...

It's so much easier with Lubix >.<

Tim.
 
i just pop an edge piece out, stick the straw into the internals and spray. if you spray until the lube starts coming out the bottom, you probably sprayed too much, but it really isnt a big deal. just make sure to pop your edge back in quickly and turn every face (like scrambling). the cube will be very hard to turn but you have to keep working at it. it will become smooth after a couple mins of scrambling.
after its smooth and fast, let it dry for about 5-10 mins. come back and it will be good!

another way you can do it is to minimize the accelerant that comes out (the stuff that makes your cube all locky and tight feeling) barely press on the spray button, like your trying to make only a little little bit come out. this is what i do with my big cubes, because i get scared of not turning every layer fast enough to not get glued together.
 
Back
Top