Prefect Tensions

I was going to let it slide as a typo, but you did it twice in a row. Spell check is not a substitute for your brain.

To answer your question: use a screwdriver. Under each center cap is a screw. Turn clockwise to tighten, counter-clockwise to loosen.
 
Last edited:
What do you mean ? Can you explain how i set it ?

EDIT: Yes i know that, i mean how loose that i will need to prefect without any pops.
 
Last edited:
There isn't a prefect tension, or a perfect tension for that matter. Just mess around with it. Set it however you want, that's the point of a DIY. If there were some universally perfect tension, then there would be no reason to have adjustable screws because anything you did to them would just mess up the perfect tension.
 
As with what the others said, "perfect" is subjective. I've heard that you should just tighten all the screws and slowly unscrew them while checking the sides. Though it's important to keep each side even, or you'll run into problems; with this method, I think it may be quite difficult, so I'd restrict myself to quarter turns of the screws, or even eighth turns.
 
If youre a perfectionist, completely unscrew the screw, and then rescrew each screw, while counting every rotation. Making sure each screw has the exact same tension.
 
Back
Top