How to stack magnets in Tengyun M 3x3

[artless1der]

I have been using my Tengyun M 3x3 as a co~main all this time since it came out, but usually as 2nd fiddle since I find the magnets to be a bit weaker than I'd like..
So I want to stack some 3x1mm magnets into the pieces. . .

But at a loss as to how to safely take the pieces on this particular puzzle apart without breaking anything

Anyone have any good info, advice, tips, hints, anecdotes??? TIA

 

[Fukuoka Kengo James]

I stacked ring magnets in the corners. I used 6-3*3 ring magnets. This definitely make the cube more stable but also make it heavier.

 

[Garf]

I stacked ring magnets in the corners. I used 6-3*3 ring magnets. This definitely make the cube more stable but also make it heavier.

I did the same here with my Tengyun, but with RS3M additional magnets.

 

[artless1der]

I stacked ring magnets in the corners. I used 6-3*3 ring magnets. This definitely make the cube more stable but also make it heavier.

Thanks for the idea, will def have to check into something like that
The Tengyun is quite light, so that probably wont make it near as heavy as the new Ballcore RS3M

 

[artless1der]

I stacked ring magnets in the corners. I used 6-3*3 ring magnets. This definitely make the cube more stable but also make it heavier.

I am still somewhat at a loss here...
How did you get the pieces apart
in order to add in extra magnets?

 

[Fukuoka Kengo James]

I am still somewhat at a loss here...
How did you get the oieces apart
in order to add in extra magnets?

Use a flat head screw driver to remove the corner caps.

 

[qwr]

I stacked ring magnets in the corners. I used 6-3*3 ring magnets. This definitely make the cube more stable but also make it heavier.

I tried putting normal circular magnets in my tengyun but I don't think it made a difference. Where did you get the ring magnets?

 

[Fukuoka Kengo James]

I tried putting normal circular magnets in my tengyun but I don't think it made a difference. Where did you get the ring magnets?

I got them for maglev before but found those only worked with my square-1s but mot my megaminxes. I ended up with doing spring swap on my yuhu v2 and got some of those magnets left sitting around in my room. Not sure why but as the edge to corner magnets on the tengyun v1 are ring magnets instead of disc magnets, these magnets fit perfectly into my tengyun v1. What disc magnets did you use?

 

[qwr]

I got them for maglev before but found those only worked with my square-1s but mot my megaminxes. I ended up with doing spring swap on my yuhu v2 and got some of those magnets left sitting around in my room. Not sure why but as the edge to corner magnets on the tengyun v1 are ring magnets instead of disc magnets, these magnets fit perfectly into my tengyun v1. What disc magnets did you use?

the extra ones the cubicle sells meant for rs3m 2020 lol