SpeedCubeReview
Member
Every couple hundred solves I completely mess up the cross by usually not aligning the edges with the centers. I would always get angry and give up on the solve. Of course I should just get better at watching for that, but I didn't realize until now that I could just flip the cube over and do an H perm or Z perm at the end to fix it... or if I accidentally switch Blue and Green during the cross that the top layer won't line up either and I can just do M2 U2 M2 U2 to fix everything. I'm sure this has been discussed in other threads but finding it out by trial and error was quite satisfying. Hopefully I don't mess up the cross that much in the future, but now that I know it is an easy fix I am not so bothered by it. I went and tested a bunch of different possibilities and all of them are easily fixable in the end.
Does anyone else who uses CFOP have this problem once and awhile? I'm sure anyone using roux sees this as obvious.
Does anyone else who uses CFOP have this problem once and awhile? I'm sure anyone using roux sees this as obvious.